Enterasys SecureStack C2 - Set Multiauth Precedence

set multiauth precedence
SecureStack C2 Configuration Guide 18-33
Syntax
clear multiauth mode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearthesystemauthenticationmode:
C2(rw)->clear multiauth mode
set multiauth precedence
Usethiscommandtosetthesystem’smultipleau thenticationadministrativeprecedence.
Syntax
set multiauth precedence {[dot1x] [mac] [pwa]}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Whenauserissuccessfullyauthenticatedbymorethanonemethodatthesametime,the
precedenceoftheauthenticationmethods willdeterminewhichRADIUS‐returnedfilterIDwillbe
processedandresultinanappliedtrafficpolicyprofile.
Example
ThisexampleshowshowtosetprecedenceforMACauthentication:
C2(rw)->set multiauth precedence mac dot1x
dot1x Setsprecedencefor802.1Xauthentication.
mac SetsprecedenceforMACauthentication.
pwa Setsprecedenceforportwebauthentication