Enterasys SecureStack C2 User Manual

show dot1x
18-10 Security Configuration
Commands
show dot1x
Usethiscommandtodisplay802.1Xstatus,diagnostics,statistics,andreauthenticationor
initializationcontrolinformationforoneormoreports.
Syntax
show dot1x [auth-diag] [auth-stats] [port [init | reauth]] [port-string]
Parameters
Defaults
Ifnoparametersarespecified,802.1Xstatuswillbedisplayed.
Ifport‐stringisnotspecified,informationforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Note: To configure EAP pass-through, which allows client authentication packets to be forwarded
through the switch to an upstream device, 802.1X authentication must be globally disabled with the
set dot1x command (“set dot1x” on page 18-13).
For information about... Refer to page...
show dot1x 18-10
show dot1x auth-config 18-11
set dot1x 18-13
set dot1x auth-config 18-13
clear dot1x auth-config 18-15
show eapol 18-15
set eapol 18-17
clear eapol 18-18
auth‐diag (Optional)Displaysauthenticationdiagnosticsinformation.
auth‐stats (Optional)Displaysauthenticationstatistics.
portinit|reauth (Optional)Displaysthestatusofportinitializationandreauthentication
controlfortheport.
port‐string (Optional)Displaysinformationforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
in
theCLI”onpage 5‐2.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English