Enterasys SecureStack C2 User Manual

set spantree spanguardtrapenable
SecureStack C2 Configuration Guide 7-29
Syntax
show spantree spanguardtrapenable
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythestateofthe S panGu ardtrapfunction:
C2(ro)->show spantree spanguardtrapenable
Spanguard SNMP traps are enabled
set spantree spanguardtrapenable
UsethiscommandtoenableordisablethesendingofanSNMPtrapmessagewhenSpanGuard
haslockedaport.
Syntax
set spantree spanguardtrapenable {disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodisabletheSpanGuardtrap function:
C2(su)->set spantree spanguardtrapenable disable
clear spantree spanguardtrapenable
UsethiscommandtoresettheSpanningTreeSpanGuardtrapfunctionbacktothedefaultstateof
enabled.
Syntax
clear spantree spanguardtrapenable
disable|enable DisablesorenablessendingSpanGuardtraps.Bydefault,sendingtraps
isenabled.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English