Enterasys SecureStack C2 - Clear Cos Settings; Show Cos Settings

clear cos settings
SecureStack C2 Configuration Guide 9-21
TheCoSIRLreferencefieldisoptional,asratelimitsarenotrequired.TheIRLreferencedoes
notassignaninboundratelimitbutpointstotheCoSIRLReferenceMappingTable.This
referencemaybethoughtofasthevirtualratelimiterthatwillassignthephysicalratelimiter
defined
bytheIRLReferenceMappingTable,describedin“setcosreference”onpage 9‐27.
Example
ThisexampleshowshowtocreateCoSentry8withapriorityvalueof3:
C2(rw)->set cos settings 8 priority 3
clear cos settings
UsethiscommandtoclearClassofServiceentrysettings.
Syntax
clear cos settings cos-list {[all] | [priority] [tos-value] [irl-reference]}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearthepriorityforCoSentry8:
C2(rw)->clear cos settings 8 priority
show cos settings
UsethiscommandtodisplayClassofServiceparameters.
Syntax
show cos settings [cos-list]
Parameters
Defaults
Ifnotspecified,allCoSentrieswillbedisplayed.
cos‐list SpecifiesaClassofServiceentrytoclear.
all Clearsallsettingsassociatedwiththisentry.
priority Clearsthepriorityvalueassociatedwiththisentry.
tos‐value ClearstheTypeofServicevalueassociatedwiththisentry.
irl‐reference CleartheIRLreferenceassociated
withthisentry.
cos‐list (Optional)SpecifiesaClassofServiceentrytodisplay.