Enterasys SecureStack C2

show lldp port status
4-16 Discovery Protocol Configuration
show lldp port status
UsethiscommandtodisplaytheLLDPstatusofoneormoreports.Thecommandliststheports
thatareenabledtosendandreceiveLLDPPDUs.Portsareenabledordisabledwiththesetlldp
portstatuscommand.
Syntax
show lldp port status [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,LLDPstatusinformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayLLDPportstatusinformationforallports.
C2(ro)->show lldp port status
Tx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12
Rx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12
show lldp port trap
UsethiscommandtodisplaytheportsthatareenabledtosendanLLDPnotificationwhena
remotesystemchangehasbeendetectedoranLLDP‐MEDnotificationwhenachangeinthe
topologyhasbeensensed.PortsareenabledtosendLLDPnotificationswiththesetlldpporttrap
command
andtosendLLDP‐MEDnotificationswiththesetlldpportmed‐trapcommand.
Syntax
show lldp port trap [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,LLDPporttrapinformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
port‐string (Optional)DisplaysLLDPstatusforoneorarangeofports.
port‐string (Optional)Displaystheportorrangeofportsthathavebeenenabled
tosendLLDPand/orLLDP‐MEDnotifications.