EasyManua.ls Logo

Enterasys SecureStack C2

Enterasys SecureStack C2
607 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
show ip ospf virtual-links
SecureStack C2 Configuration Guide 17-29
Syntax
show ip ospf neighbor [detail] [ip-address] [vlan vlan-id]
Parameters
Defaults
Ifdetailisnotspecified,summaryinformationwillbedisplayed.
Ifip‐addressisnotspecified,OSPFneighborswillbedisplayedforallIPaddressesconfiguredfor
routing.
Ifvlan‐idisnotspecified,OSPFneighborswillbedisplayedforallVLANsconfiguredforrouting.
Mode
Anyroutermode.
Example
Thisexampleshowshowtousetheshowospfneighborcommand:
C2(su)->router#show ip ospf neighbor
ID Pri State Dead-Int Address Interface
182.127.62.1 1 FULL 40 182.127.63.1 vlan1
Table 17‐5providesanexplanationofthecommandoutput.
show ip ospf virtual-links
Usethiscommandtodisplayinformationaboutthevirtuallinksconfiguredonarouter.Avirtual
linkrepresentsalogicalconnectionbetweenthebackboneandanon‐backboneOSPFarea.
detail (Optional)Displaysdetailedinformationabouttheneighbors,includingthe
areainwhichtheyareneighbors,whothedesignatedrouter/backup
designatedrouter
isonthesubnet,ifapplicable,andthedecimalequivalent
oftheE‐bitvaluefromthehellopacketoptionsfield.
ip‐address (Optional)DisplaysOSPFneighborsforaspecificIPaddress.
vlanvlan‐id (Optional)DisplaysOSPFneighborsforaspecificVLAN.ThisVLANmust
beconfiguredforIProutingasdescribed
in“Pre‐RoutingConfiguration
Tasks”onpage15‐1.
Table 17-5 show ip ospf neighbor Output Details
Output What It Displays...
ID Neighbor’s router ID of the OSPF neighbor.
Pri Neighbor’s priority over this interface.
State Neighbor’s OSPF communication state.
Dead-Int Interval (in seconds) this router will wait without receiving a Hello packet from a
neighbor before declaring the neighbor is down.
Address Neighbor’s IP address.
Interface Neighbor’s interface (VLAN).

Table of Contents

Related product manuals