Enterasys SecureStack C2 - Show Cos Reference

show cos reference
9-28 Policy Classification Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
TheCoSreferencetablemapstheuser‐definedIRLreferencesfoundintheCoSsettingstable(see
“setcossettings”onpage 9‐20)toratelimiterscreatedintheportresourcetable(see“setcosport‐
resource”onpage 9‐25).TheCoSreferencetableindexescanbethoughtof
asvirtualratelimiters.
Thetableaccountsforthemaximumnumberofratelimiterssupportedbythedevice.Thevirtual
limitersthenmaptothephysicalratelimiters.TheCoSIRLReferenceTableisnotconfiguredby
default.
TheCoSIRLreferencetableuses100indexesorvirtualratelimiters,and
mapseachvirtuallimiter
toaphysicallimiterorresource.AnIRLreferencetableexistsforeachportgroupconfigured,and
isindexedsimilarlytoportresources,asportgroup#,port‐type,reference.IRLreferencesarenot
populatedwithlimiters(resources),butcanbeconfiguredbytheuser.TheIRL
referencetablecan
bedisplayedusingtheshowcosreferencecommand.
Example
IntheCoSIRLreferencemappingtableforportgroups1.0and2.0,createareferencefortheIRL
resourcenumber1createdforeachgroup.Thereferencenumber1isused.
C2(su)->set cos reference irl 1.0 1 rate-limit 1
C2(su)->set cos reference irl 2.0 1 rate-limit 1
show cos reference
UsethiscommandtoshowtheClassofServiceinboundratelimitingreferenceconfiguration.
Syntax
show cos reference [irl [group-type-index]]
Parameters
Defaults
Ifirlisnotspecified,allCoSreferenceinformationisdisplayed.
Ifaspecificportgroupisnotspecified,informationfor allportgroupsisdisplayed.
rate‐limitirl‐index Ratelimiter(IRLresourceindex)tobindthisreferenceto.Validvalues
rangefrom0to99.
irl (Optional)Specifiesthatinboundratelimitingreferenceinformation
shouldbedisplayed.
group‐type‐index (Optional)Specifiesaninboundratelimitingportgroup/typeindex.
Validentriesareinthe formofgroup#.port‐type.
Validvaluesforgroup#canrangefrom0to7.Validvaluesforport‐type
canrangefrom0
to1,althoughonlyporttype0iscurrentlysupported.
Forexample,portgroup3wouldbespecifiedas3.0.