Enterasys SecureStack C2 User Manual

disconnect
12-14 Logging and Network Management
Syntax
show users
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtousetheshowuserscommand.Inthisoutput,therearetwoTelnet
usersloggedinwithRead‐WriteaccessprivilegesfromIPaddresses134.141.192.119and
134.141.192.18:
C2(su)->show users
Session User Location
-------- ----- --------------------------
* telnet rw 134.141.192.119
telnet rw 134.141.192.18
disconnect
UsethiscommandtocloseanactiveconsoleportorTelnetsessionfromtheswitchCLI.
Syntax
disconnect {ip-addr | console}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Examples
ThisexampleshowshowtocloseaTelnetsessiontohost134.141.192.119:
C2(su)->disconnect 134.141.192.119
Thisexampleshowshowtoclosethecurrentconsolesession:
C2(su)->disconnect console
ip‐addr SpecifiestheIPaddressoftheTelnetsessiontobedisconnected.This
addressisdisplayedintheoutputshownin“showusers”onpage 12‐15.
console Closesanactiveconsoleport.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English