Enterasys SecureStack C2

set cos port-config
9-22 Policy Classification Configuration
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtoshowallCoSsettings:
C2(su)->show cos settings
CoS Index Priority ToS IRL
--------- ---------- ------- -----
0 0 * *
1 1 * *
2 2 * *
3 3 * *
4 4 * *
5 5 * *
6 6 * *
7 7 * *
set cos port-config
Usethiscommandtocreateaportgroupforinboundratelimitingandaddorremoveportsfrom
thegroup.
Syntax
set cos port-config irl group-type-index [name name] [ports port-list] [append] |
[clear]
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
irl Specifiesthatthisisan inboundratelimiting(IRL)portgroup.
group‐type‐index Specifiesaninboundratelimitingportgroup/typeindex.Validentries
areintheformofgroup#.port‐type.
Validvaluesforgroup#canrangefrom0to7.Validvaluesforport‐type
can
rangefrom0to1,althoughonlyporttype0iscurrentlysupported.
Forexample,portgroup3wouldbespecifiedas3.0.
namename (Optional)Userdefinednameforthegroup.
portsport‐list (Optional)Portsassignedtothegroup.Allportsmustbeofthesameport
type(Fast
Ethernet,GigabitEthernet).
append (Optional)Append(add)theportstotheportsthatarealreadyinthe
group.
clear (Optional)Clearthegivenportsfromthoseassignedtothegroup.