Enterasys SecureStack C2

clear snmp community
6-14 SNMP Configuration
Defaults
Ifsecuritynameisnotspecified,thecommunitynamewillbeused.
Ifcontextisnotspecified,accesswillbegrantedforthedefaultcontext.
Iftransporttagisnotspecified,nonewillbeapplied.
Ifstoragetypeisnotspecified,nonvolatilewillbeapplied.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetanSNMPcommunitynamecalled“vip”
C2(su)->set snmp community vip
clear snmp community
UsethiscommandtodeleteanSNMPcommunityname.
Syntax
clear snmp community name
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtodeletethecommunityname“vip.”
C2(su)->clear snmp community vip
contextcontext (Optional)Specifiesasubsetofmanagementinformationthiscommunity
willbeallowedtoaccess.Validvaluesarefullorpartialcontextnames.To
reviewallcontextsconfiguredforthedevice,usetheshowsnmpcontext
commandasdescribedin“showsnmpcontext”onpage 6‐20.
transporttransport (Optional)Specifies
thesetoftransportendpointsfromwhichSNMP
requestwiththiscommunitynamewillbeaccepted.Makesalinktoa
targetaddresstable.
volatile|
nonvolatile
(Optional)Specifiesthestoragetypefortheseentries.
name SpecifiestheSNMPcommunitynametoclear.