Enterasys SecureStack C2

clear cos reference
SecureStack C2 Configuration Guide 9-29
Mode
Switchcommand,read‐only.
Example
ThisexampleshowstheClassofServiceIRLreferencesforportgroup1.0.Notethatnotallofthe
100possiblereferencesaredisplayedinthisoutputexample.
C2(su)->show cos reference irl 1.0
Group Index Reference Type Rate Limiter
----------- --------- ---- ------------
1.0 0 irl none
1.0 1 irl 1
1.0 2 irl none
1.0 3 irl none
...
1.0 97 irl none
1.0 98 irl none
1.0 99 irl none
clear cos reference
UsethiscommandtocleartheClassofServiceinboundratelimiting referenceconfiguration.
Syntax
clear cos reference irl {all | group-type-index reference}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocleartheCoSinboundratelimitingreferenceconfigurationforall
groups:
C2(su)->clear cos reference irl all
irl SpecifiesthatIRLreferencesarebeingcleared.
all Clearallgroupsindexesandreferences.
group‐type‐index Specifiesaninboundratelimitingportgroup/typeindex.Validentries
areintheformofgroup#.port‐type.
Validvaluesforgroup#canrangefrom0to7.Validvaluesforport‐type
canrange
from0to1,althoughonlyporttype0iscurrentlysupported.
Forexample,portgroup3wouldbespecifiedas3.0.
reference Clearaspecificreferenceforthespecifiedportgroup.