Enterasys SecureStack C2 - Set Ssl; Show Ssl

show ssl
3-50 Basic Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
ItisgoodpracticeforsecurityreasonstodisableHTTPaccessontheswitchwhenfinished
configuringwithWebView,andthentoonlyenableWebViewontheswitchwhenchangesneed
tobemade.
Example
ThisexampleshowshowtodisableWebViewontheswitch:
C2(rw)->set webview disable
show ssl
UsethiscommandtodisplaySSLstatus.
Syntax
show ssl
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaySSLstatus:
C2(rw)->show ssl
SSL status: Enabled
set ssl
UsethiscommandtoenableordisabletheuseofWebViewoverSSLport443.Bydefault,SSLis
disabledontheswitch.Thiscommandcanalsobeusedtoreinitializethehostkeythatisusedfor
encryption.
Syntax
set ssl {enabled | disabled | reinitialize | hostkey reinitialize}