Enterasys SecureStack C2 User Manual

clear radius accounting
SecureStack C2 Configuration Guide 18-9
Examples
ThisexampleshowshowtoenabletheRADIUSaccountingclientforauthenticati ngwiththe
accountingserveratIPaddress10.2.4.12,UDPauthenticationport1800. Aspreviouslynoted,the
“serversecret”passwordenteredheremustmatchthatalreadyconfiguredastheRead‐Write(rw)
passwordontheRADIUSaccountingserver:
C2(su)->set radius accounting server 10.2.4.12 1800
Enter secret:
Re-enter secret:
ThisexampleshowshowtosettheRADIUSaccountingtimeoutto30seconds:
C2(su)->set radius accounting timeout 30
ThisexampleshowshowtosetRADIUSaccountingretriesto10:
C2(su)->set radius accounting retries 10
clear radius accounting
UsethiscommandtoclearRADIUSaccountingconfigurationsettings.
Syntax
clear radius accounting {server ip-address | retries | timeout | counter}
Parameters
Mode
Switchcommand,read‐write.
Defaults
None.
Example
ThisexampleshowshowtoresettheRADI US accountingtimeoutto5seconds.
C2(su)->clear radius accounting timeout
Configuring 802.1X Authentication
Purpose
Toreviewandconfigure802.1XauthenticationforoneormoreportsusingEAPOL(Extensible
AuthenticationProtocol).802.1Xcontrolsnetworkaccessbyenforcinguserauthorizationon
selectedports,whichresultsinallowingordenyingnetworkaccessaccordingtoRADIUSserver
configuration.
serverip‐address Clearstheconfigurationononeormoreaccountingservers.
retries Resetstheretriestothedefaultvalueof3.
timeout Resetsthetimeoutto5seconds.
counter Clearscounters.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English