Enterasys SecureStack C2

set cos state
9-18 Policy Classification Configuration
3 3 * *
4 4 * *
5 5 * *
6 6 * *
7 7 * *
Commands
set cos state
UsethiscommandtoenableordisableClassofService.
Syntax
set cos state {enable | disable}
Parameters
Defaults
None.
For information about... Refer to page...
set cos state 9-18
show cos state 9-19
clear cos state 9-19
set cos settings 9-20
clear cos settings 9-21
show cos settings 9-21
set cos port-config 9-22
show cos port-config 9-23
clear cos port-config 9-24
set cos port-resource 9-25
show cos port-resource 9-26
clear cos port-resource 9-26
set cos reference 9-27
show cos reference 9-28
clear cos reference 9-29
show cos unit 9-30
clear cos all-entries 9-30
show cos port-type 9-31
enable|disable EnablesordisablesClassofServiceontheswitch.Defaultstateis
disabled.