Enterasys SecureStack C2

clear port ratelimit
10-12 Port Priority and Rate Limiting Configuration
Example
Thisexampleshowshowto:
• globallyenableratelimiting
• configureratelimitingforinboundtrafficonport
ge.2.1,index1,priority5,toathreshold of
125 KBps:
C2(rw)->set port ratelimit enable
C2(rw)->set port ratelimit ge.2.1 5 125 enable inbound
clear port ratelimit
Usethiscommandtoclearratelimitingparametersforoneormoreports.
Syntax
clear port ratelimit port-string [index]
Parameters
Defaults
Ifnotspecified,allindexentrieswillbereset.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearallratelimitingparametersonportge.2.1.
C2(su)->clear port ratelimit ge.2.1
port‐string Specifiestheport(s)onwhichtoclearratelimiting.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 5‐2.
index (Optional)Specifiestheassociatedresourceindextobereset.