Enterasys SecureStack C2

ip rip receive version
SecureStack C2 Configuration Guide 17-5
ip rip receive version
UsethiscommandtosettheRIPversion(s)forupdatepacketsacceptedontheinterface.Theno
formofthiscommandrestoresthedefaultversionoftheRIProuterupdatepacketsthatare
acceptedontheinterface.
Syntax
ip rip receive version {1 | 2 | 1 2 | none}
no ip rip receive version
Parameters
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Defaults
None.
Example
ThisexampleshowshowtosettheRIPreceiveversionto2forupdatepacketsreceivedonthe
VLAN1interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip rip receive version 2
ip rip authentication-key
UsethiscommandtoenableordisableaRIPauthenticationkey(password)foruseonan
interface.ThenoformofthiscommandpreventsRIPfromusingauthentication.
Syntax
ip rip authentication-key name
no ip rip authentication key
Parameters
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
1 SpecifiesRIPversion1.Thisisthedefaultsetting.
2 SpecifiesRIPversion2.
12 SpecifiesRIPversions1and2.
none SpecifiesthatnoRIProuteswillbeprocessedonthisinterface.
name SpecifiesthepasswordtoenableordisableforRIPauthentication.