Enterasys SecureStack C2

show macauthentication
18-20 Security Configuration
show macauthentication
UsethiscommandtodisplayMACauthenticationinformationforoneormoreports.
Syntax
show macauthentication [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,MACauthenticationinformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayMACauthenticationinformationforge.2.1through8:
C2(su)->show macauthentication ge.2.1-8
MAC authentication: - enabled
MAC user password: - NOPASSWORD
Port username significant bits - 48
Port Port Reauth Auth Auth Reauthentications
State Period Allowed Allocated
------- -------- ---------- -------- --------- -----------------
ge.2.1 disabled 3600 1 1 disabled
ge.2.2 disabled 3600 1 1 disabled
ge.2.3 disabled 3600 1 1 disabled
ge.2.4 disabled 3600 1 1 disabled
ge.2.5 disabled 3600 1 1 disabled
ge.2.6 disabled 3600 1 1 disabled
ge.2.7 disabled 3600 1 1 disabled
ge.2.8 disabled 3600 1 1 disabled
Table 18‐3providesanexplanationofthecommandoutput.
clear macauthentication significant-bits 18-29
For information about... Refer to page...
port‐string (Optional)DisplaysMACauthenticationinformationforspecificport(s).
Foradetaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 5‐2.
Table 18-3 show macauthentication Output Details
Output What It Displays...
MAC authentication Whether MAC authentication is globally enabled or disabled. Set using the set
macauthentication command as described in “set macauthentication” on
page 18-22.
MAC user password User password associated with MAC authentication on the device. Set using the set
macauthentication password command as described in “set macauthentication
password” on page 18-22.