clear policy port
SecureStack C2 Configuration Guide 9-15
Example
ThisexampleshowshowtoallowGigabitEthernetports5through15inslot1totransmitframes
accordingtopolicyprofile1:
C2(su)->set policy port ge.1.5-15 1
clear policy port
Usethiscommandtoremoveapolicyprofilefromoneormoreports.
Syntax
clear policy port port-string profile-index
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoremovepolicyprofile10fromport21inslot1:
C2(rw)->clear policy port ge.1.21 10
Configuring Policy Class of Service (CoS)
Using Port-Based or Policy-Based CoS Settings
TheSecureStackC2supportsClassofService(CoS),whichallowsyoutoassignmission‐critical
datatoahigherprioritythroughthedevicebydelayinglesscriticaltrafficduringperiodsof
congestion.Thehigherprioritytrafficgoingthroughthedeviceisservicedfirst(beforelower
prioritytraffic).TheClassofService
capabilityofthedeviceisimplementedbyapriority
queueingmechanism.ClassofServiceisbasedontheIEEE802.1D(802.1p)standardspecification,
andallowsyoutodefineeightpriorities(0‐7,with7grantedhighestpriority)andupto8transmit
queues(0‐7)foreachport.
port‐string Specifies
theport(s)fromwhichtoremovethepolicyprofile.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 5‐2.
profile‐index SpecifiestheIDofthepolicyprofile(role)towhichtheport(s)willbe
added.Thisvaluemustmatch
theprofile‐indexvalueassignedusing the
setpolicyprofilecommand(“setpolicyprofile”onpage 9‐3)inorderfor
apolicyprofiletobeactiveonthespecifiedport.
Note: It is recommended that you use Enterasys Networks NetSight Policy Manager as an
alternative to CLI for configuring policy-based CoS on the switches.
To Next Page
Loading...
Need help?
General