Enterasys SecureStack C2

clear tftp retry
SecureStack C2 Configuration Guide 3-45
Example
Thisexamplesetstheretrycountto3.
C2(rw)->set tftp retry 3
clear tftp retry
UsethiscommandtoresettheTFTPretryvaluetothedefaultvalueof5retries.
Syntax
clear tftp retry
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtocleartheretryvaluetothedefaultof5retries.
C2(rw)-> clear tftp retry
Clearing and Closing the CLI
Purpose
TocleartheCLIscreenortocloseyourCLIsession.
Commands
ThecommandsusedtoclearandclosetheCLIsessionarelistedbelow.
cls (clear screen)
UsethiscommandtoclearthescreenforthecurrentCLIsession.
Syntax
cls
For information about... Refer to page...
cls 3-45
exit 3-46