Enterasys SecureStack C2

ip pimsm staticrp
17-46 IPv4 Routing Protocol Configuration
Example
ThisexampleshowshowtogloballyenableanddisablePIM:
C2(su)->router(Config)# ip pimsm
C2(su)->router(Config)# no ip pimsm
ip pimsm staticrp
ThiscommandisusedtocreateamanualRendezvousPointIPaddressforthePIM‐SMrouter.
ThenoformofthiscommandremovesapreviouslyconfiguredRP.
Syntax
ip pimsm staticrp ipaddress groupadress groupmask
no ip pimsm staticrp ipaddress groupadress groupmask
Parameters
Defaults
None.
Mode
GlobalRouterconfiguration:C2(su)‐>router(Config)#
Example
ThisexampleshowshowtosetanRPforaspecificmu lticastgrou p.
C2(su)->router(Config)# ip pimsm staticrp 192.15.18.3 224.0.0.0 240.0.0.0
ip pimsm enable
ThiscommandsetstheadministrativemodeofPIM‐SMmulticas troutingonaroutinginterfaceto
enabled.Bydefault,PIMisdisabledonallIPinterfaces.Thenoformofthiscommanddisables
PIMonthespecificinterface.
Syntax
ip pimsm enable
no ip pimsm enable
Parameters
None.
Defaults
None.
ipaddress TheIPaddressoftheRendezvousPoint
groupadress ThegroupaddresssupportedbytheRendezvousPoint
groupmask Thegroupmaskforthegroupaddress