Enterasys SecureStack C2

clear multiauth idle-timeout
SecureStack C2 Configuration Guide 18-39
clear multiauth idle-timeout
Usethiscommandtoresetthemaximumnumberofconsecutivesecondsanauthenticatedsession
maybeidlebeforeterminationofthesessiontoitsdefaultvalueof0.
Syntax
clear multiauth idle-timeout [dot1x | mac | pwa]
Parameters
Defaults
Ifnoauthenticationmethodisspecified,theidletimeoutvalueisresettoitsdefaultvalueof 0for
allauthenticationmethods.
Mode
Switchmode,read‐write.
Example
Thisexampleresetstheidletimeoutvalueforallauthenticationmethodsto0seconds.
C2(su)->clear multiauth idle-timeout
show multiauth session-timeout
Usethiscommandtodisplaythesessiontimeoutvalue,inseconds,forallauthenticationmethods.
Syntax
show multiauth session-timeout
Parameters
None.
Defaults
None.
Mode
Switchmode,read‐only.
dot1x (Optional)SpecifiestheIEEE802.1Xport‐basednetworkaccesscontrol
authenticationmethodforwhichtoresetthetimeoutvaluetoits
default.
mac (Optional)SpecifiestheEnterasysMACauthenticationmethodfor
whichtoresetthetimeoutvaluetoitsdefault.
pwa (Optional)SpecifiestheEnterasysPortWebAuthentication
methodfor
whichtoresetthetimeoutvaluetoitsdefault.