To Next Page

To Previous Page

show radius

18-4 Security Configuration

show radius

UsethiscommandtodisplaythecurrentRADIUSclient/serverconfiguration.

Syntax

show radius [status | retries | timeout | server [index | all]]

Parameters

Defaults

Ifnoparametersarespecified,allRADIUSconfigurationinformationwillbedisplayed.

Mode

Switchcommand,read‐only.

Example

ThisexampleshowshowtodisplayRADIUSconfigurationinformation:

C2(rw)->show radius

RADIUS status: Enabled

RADIUS retries: 3

RADIUS timeout: 20 seconds

RADIUS Server IP Address Auth-Port Realm-Type

-------------- ---------- --------- -----------------

10 172.16.20.10 1812 management-access

Table 18‐1providesanexplanationofthecommandoutput.

set radius 18-5

clear radius 18-7

show radius accounting 18-7

set radius accounting 18-8

clear radius accounting 18-9

For information about... Refer to page...

status (Optional)DisplaystheRADIUSserver’senablestatus.

retries (Optional)DisplaysthenumberofretryattemptsbeforetheRADIUSserver

timesout.

timeout (Optional)Displaysthemaximumamountoftime(inseconds)toestablish

contactwiththeRADIUSserverbeforeretryattemptsbegin.

server(Optional)DisplaysRADIUSserverconfigurationinformation.

index|all Foruse

withtheserverparametertoshowserverconfigurationforall

serversoraspecificRADIUSserverasdefinedbyanindex.

Table 18-1 show radius Output Details

Output What It Displays...

RADIUS status Whether RADIUS is enabled or disabled.

Enterasys SecureStack C2 User Manual

Questions and Answers: