Enterasys SecureStack C2 User Manual

router id
SecureStack C2 Configuration Guide 17-11
router id
UsethiscommandtosettheOSPFrouterIDforthedevice.ThisIPaddressmustbesetmanually
inordertorunOSPF.ThenoformofthiscommandremovestherouterIDforthedevice.
Syntax
router id ip-address
no router id
Parameters
Defaults
None.
Mode
Routerconfiguration:C2(su)‐>router(Config‐router)#
• Configure OSPF authentication. “ip ospf authentication-key” on page 17-18
“ip ospf message digest key md5” on page 17-19
Configure OSPF Areas.
• Configure an administrative distance. “distance ospf” on page 17-19
• Define the range of addresses to be used
by Area Boundary Routers (ABRs).
“area range” on page 17-20
• Define an area as a stub area. “area stub” on page 17-21
• Set the cost value for the default route that
is sent into a stub area.
“area default cost” on page 17-22
• Define an area as an NSSA. “area nssa” on page 17-22
Create virtual links. “area virtual-link” on page 17-23
Enable redistribution from non-OSPF
routes.
“redistribute” on page 17-24
Monitor and maintain OSPF. “show ip ospf” on page 17-25
“show ip ospf neighbor” on page 17-28
“show ip ospf interface” on page 17-27
“show ip ospf neighbor” on page 17-28
“show ip ospf virtual-links” on page 17-29
“clear ip ospf process” on page 17-30
Table 17-2 OSPF Configuration Task List and Commands (Continued)
To do this... Use these commands...
ip‐address SpecifiestheIPaddressthatOSPFwilluseastherouterID.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English