Enterasys SecureStack C2

clear rmon event
13-14 RMON Configuration
Mode
Switchcommand,read‐write.
Usage
AnRMONevententrycanbecreatedusing thiscommand,configuredusingthesetrmonevent
propertiescommand(“setrmoneventproperties”onpage 13‐12),thenenabledusingthis
command.AnRMONevententrycanbecreatedandconfiguredatthesametimebyspecifyingan
unusedindexwiththe
setrmoneventpropertiescommand.
Example
ThisexampleshowshowtoenableRMONevententry1:
C2(rw)->set rmon event status 1 enable
clear rmon event
UsethiscommandtodeleteanRMONevententryandanyassociatedlogentries.
Syntax
clear rmon event index
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearRMONevent1:
C2(rw)->clear rmon event 1
Filter Group Commands
Thepacketcaptureandfilterfunctionisdisabledbydefault.Onlyoneinterfacecanbeconfigured
forcapturingandfilteringatatime.
Whenpacketcaptureisenabledonan interface,theSecureStackC2switchwillcapture100frames
asclosetosequentiallyaspossible.These100frameswillbeplaced
intoabufferforinspection.If
thereisdatainthebufferwhenthefunctionisstarted,thebufferwillbeoverwritten.Once100
frameshavebeencaptured,thecapturewillstop.Filteringwillbeperformedontheframes
capturedinthebuffer.Therefore,onlyasubsetoftheframes
capturedwillbeavailablefor
display.
index Specifiestheindexnumberoftheentrytobecleared.
Note: Packet capture is sampling only and does not guarantee receipt of back to back packets.