Enterasys SecureStack C2

set spantree priority
SecureStack C2 Configuration Guide 7-17
set spantree priority
Usethiscommandtosetthedevice’sSpanningTreepriority.
Syntax
set spantree priority priority [sid]
Parameters
Defaults
Ifsidisnotspecified,prioritywillbesetonSpanningTree0.
Mode
Switchcommand,read‐write.
Usage
Thedevicewiththehighestpriority(lowestnumericalvalue)becomestheSpanningTreeroot
device.Ifalldeviceshavethesamepriority,thedevicewiththelowestMACaddresswillthen
becometherootdevice.Dependingonthebridgeprioritymode(setwiththesetspantree 
bridgeprioritymodecommanddescribedin“
setspantreebridgeprioritymode”onpage 7‐10,
somepriorityvaluesmayberoundedupordown.
Example
Thisexampleshowshowtosetthebridgepriorityto4096onSID1:
C2(su)->set spantree priority 4096 1
clear spantree priority
UsethiscommandtoresettheSpanningTreeprioritytothedefaultvalueof32768.
Syntax
clear spantree priority [sid]
Parameters
Defaults
Ifsidisnotspecified,prioritywillberesetonSpanningTree0.
Mode
Switchcommand,read‐write.
priority Specifiesthepriorityofthebridge.Validvaluesarefrom0to61440(in
incrementsof4096),with0indicatinghighestpriorityand61440
lowestpriority.
sid (Optional)SetsthepriorityonaspecificSpanningTree.Validvalues
are0‐4094.Ifnotspecified,SID 0is
assumed.
sid (Optional)ResetsthepriorityonaspecificSpanning Tree.Valid
valuesare0‐4094.Ifnotspecified,SID 0isassumed.