Enterasys SecureStack C2

set system name
3-22 Basic Configuration
set system name
Usethiscommandtoconfigureanameforthesystem.
Syntax
set system name [string]
Parameters
Defaults
Ifstringisnotspecified,thesystemnamewillbecleared.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetthesystemnametoInformationSystems:
C2(su)->set system name “Information Systems”
set system location
Usethiscommandtoidentifythelocationofthesystem.
Syntax
set system location [string]
Parameters
Defaults
Ifstringisnotspecified,thelocationnamewillbecleared.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthesystemlocationstring:
C2(su)->set system location “Bldg N32-04 Closet 9”
string (Optional)Specifiesatextstringthatidentifiesthesystem.
Note: A name string containing a space in the text must be enclosed in
quotes as shown in the example below.
string (Optional)Specifiesatextstringthatindicateswherethesystemis
located.
Note: A location string containing a space in the text must be
enclosed in quotes as shown in the example below.