Enterasys SecureStack C2 User Manual

clear ip ospf process
17-30 IPv4 Routing Protocol Configuration
Syntax
show ip ospf virtual-links
Parameters
None.
Defaults
None.
Mode
Anyroutermode.
Example
ThisexampleshowshowtodisplayOSPFvirtuallinksinformation:
C2(su)->router#show ip ospf virtual-links
Neighbor ID 155.155.155.155
Transit area 0.0.0.8
Transmit delay is 1 sec State point-to-point
Timer intervals configured:
Hello 10, Dead 40, Retransmit 5
Adjacency State Full
Table 17‐6providesanexplanationofthecommandoutput.
clear ip ospf process
UsethiscommandtoresettheOSPFprocess.Thiswillrequireadjacenciestobereestablishedand
routestobereconverged.
Syntax
clear ip ospf process process-id
Parameters
Table 17-6 show ip ospf virtual links Output Details
Output What It Displays...
Neighbor ID ID of the virtual link neighbor, and the virtual link status, which is up or down.
Transit area ID of the transit area through which the virtual link is configured.
Transmit delay Amount of time required to transmit a link state update packet on an interface.
State Whether the state of this interface is down or point-to-point.
Timer intervals
configured
Timer intervals configured for the virtual link, including Hello, Wait, and Retransmit
intervals.
Adjacency State State of adjacency between this router and the virtual link neighbor of this router.
process‐id SpecifiestheprocessID,aninternallyusedidentificationnumberforeach
instanceoftheOSPFroutingprocessrunonarouter.Validvaluesare1to
65535.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English