To Next Page

To Previous Page

set policy rule

SecureStack C2 Configuration Guide 9-9

Example

Thisexampleshowshowtodisplaythedevice’spolicyclassificationcapabilities.Referto“set

policyrule”onpage 9‐9foradescriptionoftheparametersdisplayed:

C2(su)->show policy capability

The following supports related to policy are supported in this device:

VLAN Forwarding Priority Permit

Deny Precedence Reordering Rules Table

Rule-Use Notification Longest Prefix Rules

=============================================================

| | D | | | | | F | | | D |

| | Y | | | | | O | S | | I |

| | N | A | | | | R | Y | | S |

| | A | D | V | | D | W | S | T | A |

| | M | M | L | C | R | A | L | R | B |

| | I | I | A | O | O | R | O | A | L |

| SUPPORTED RULE TYPES | C | N | N | S | P | D | G | P | E |

=============================================================

|MAC source address | | | | X | X | X | | | |

|MAC destination address | | | | X | X | X | | | |

|IP source address | | | | X | X | X | | | |

|IP destination address | | | | X | X | X | | | |

|UDP port source | | | | X | X | X | | | |

|UDP port destination | | | | X | X | X | | | |

|TCP port source | | | | X | X | X | | | |

|TCP port destination | | | | X | X | X | | | |

|ICMP packet type | | | | X | X | X | | | |

|TTL | | | | | | | | | |

|IP type of service | | | | X | X | X | | | |

|IP proto | | | | X | X | X | | | |

|Ether II packet type | | | X | X | X | X | | | |

|Port string | X | X | X | X | X | X | | | |

=============================================================

set policy rule

UsethiscommandtoassignincominguntaggedframestoaspecificpolicyprofileandtoVLANor

Class‐of‐Serviceclassificationrules.

Syntax

Thiscommandhastwoformsofsyntax—onetocreateanadminrule(forpolicyID0),andthe

othertocreateaclassificationruleandattach ittoapolicyprofile.

Enterasys SecureStack C2 User Manual

Questions and Answers: