Enterasys SecureStack C2

show ip igmp groups
11-12 IGMP Configuration
Example
ThisexampleshowshowtodisplayIGMProutinginformationforVLAN1:
C2(su)->router#show ip igmp interface vlan 1
Vlan 1 is Admin UP
Vlan 1 is Oper UP
IGMP is configured via the Switch
IGMP ACL currently not supported
Multicast TTL currently defaults to 1
IGMP Version is 2
Query Interval is 125 (secs)
Query Max Response Time is 100 (1/10 of a second)
Robustness is 2
Startup Query Interval is 31 (secs)
Startup Query Count is 2
Last Member Query Interval is 10 (1/10 of a second)
Last Member Query Count is 2
show ip igmp groups
UsethiscommandtodisplayalistofIGMPstreamsandclientconnectionports.
Syntax
show ip igmp groups
Parameters
None.
Defaults
None.
Mode
Anyroutermode.
Example
ThisexampleshowshowtodisplayinformationaboutIGMPgroups:
C2(su)->router#show ip igmp groups
REGISTERED MULTICAST GROUP DETAILS
Multicast Version1
IP Address Last Reporter Up Time Expiry Time Host Timer
--------------- --------------- ------- ------------ ------------ ----------
228.1.1.1 12.12.12.2 27
ip igmp query-interval
UsethiscommandtosettheIGMPqueryintervalonaroutinginterface.Thenoformofthis
commandresetstheIGMPqueryintervaltothedefaultvalueof125seconds.
Syntax
ip igmp query-interval time
no ip igmp query-interval