Enterasys SecureStack C2

clear dhcp pool default-router
SecureStack C2 Configuration Guide 14-23
Syntax
set dhcp pool poolname default-router address [address2 ... address8]
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleassignsadefaultrouterat10.10.10.1 totheaddresspoolnamed“auto1.”
C2(rw)->set dhcp pool auto1 default-router 10.10.10.1
clear dhcp pool default-router
Usethiscommandtodeletethedefaultroutersconfiguredforthisaddresspool.
Syntax
clear dhcp pool poolname default-router
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleremovesthedefaultrouterfromtheaddresspool“auto1.”
C2(rw)->clear dhcp pool auto1 default-router
set dhcp pool dns-server
UsethiscommandtospecifyoneormoreDNSserversfortheDHCPclientsservedbytheaddress
poolbeingconfigured.Upto8DNSserverscanbeconfigured.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
address SpecifiestheIPaddressof
adefaultrouter.
address2...address8 (Optional)Specifies,inorderofpreference,upto7additionaldefault
routeraddresses.
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.