Enterasys SecureStack C2

show spantree stats
SecureStack C2 Configuration Guide 7-5
show spantree stats
UsethiscommandtodisplaySpanningTreeinformationforoneormoreports.
Syntax
show spantree stats [port port-string] [sid sid] [active]
Parameters
Defaults
Ifport‐stringisnotspecified,SpanningTreeinformation forallportswillbedisplayed.
Ifsidisnotspecified,informationforSpanningTree0willbedisplayed.
Ifactiveisnotspecifiedinformationforallportswillbedisplayedregardlessofwhetherornot
theyhavereceivedBPDUs.
Mode
Switchcommand,read‐only.
set spantree protomigration 7-24
show spantree spanguard 7-24
set spantree spanguard 7-25
clear spantree spanguard 7-26
show spantree spanguardtimeout 7-26
set spantree spanguardtimeout 7-26
clear spantree spanguardtimeout 7-27
show spantree spanguardlock 7-27
clear/set spantree spanguardlock 7-28
show spantree spanguardtrapenable 7-28
set spanstree spanguardtrapenable 7-29
clear spanstree spanguardtrapenable 7-29
show spantree legacypathcost 7-30
set spantree legacypathcost 7-30
clear spantree legacypathcost 7-31
For information about... Refer to page...
portport‐string (Optional)Displaysinformationforthespecifiedport(s).Foradetailed
descriptionofpossibleport‐‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 5‐2.
sidsid (Optional)DisplaysinformationforaspecificSpanningTreeidentifier.If
notspecified,SID0isassumed.
active (Optional)Displaysinformation
forportsthathavereceivedSTPBPDUs
sinceboot.