Enterasys SecureStack C2

ip dvmrp enable
17-32 IPv4 Routing Protocol Configuration
Syntax
ip dvmrp
no ip dvmrp
Parameters
None.
Defaults
None.
Mode
Globalconfiguration:C2(su)‐>router(Config)#
Example
ThisexampleshowshowtoenabletheDVMRPprocess:
C2(su)->router(Config)#ip dvmrp
ip dvmrp enable
UsethiscommandtoenableDVMRPonaninterface.Thenoformofthiscommanddisables
DVMRPonaninterface:
Syntax
ip dvmrp enable
no ip dvmrp enable
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenableDVMRPontheVLAN1interface:
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip dvmrp enable
ip dvmrp metric
UsethiscommandtoconfigurethemetricassociatedwithasetofdestinationsforDVMRP
reports.
Syntax
ip dvmrp metric metric