Enterasys SecureStack C2 User Manual

Starting and Configuring Telnet
3-34 Basic Configuration
Example
Thisexampleshowshowtosetthebootfirmwareimagefileto“newimage”:
C2(su)->set boot system newimage
Starting and Configuring Telnet
Purpose
ToenableordisableTelnet,andtostartaTelnetsessiontoaremotehost.TheSecureStackC2
switchallowsatotaloffourinboundand/oroutboundTelnetsessiontorunsimultaneously.
Commands
Thecommandsusedtoenable,startandconfigureTelnetarelistedbelow.
show telnet
UsethiscommandtodisplaythestatusofTelnetontheswitch.
Syntax
show telnet
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayTelnetstatus:
C2(su)->show telnet
Telnet inbound is currently: ENABLED
Telnet outbound is currently: ENABLED
set telnet
UsethiscommandtoenableordisableTelnetontheswitch.
For information about... Refer to page...
show telnet 3-34
set telnet 3-34
telnet 3-35

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English