Enterasys SecureStack C2

show webview
SecureStack C2 Configuration Guide 3-49
section.WebViewcanalsobe securelyusedoverSSLport443,ifSSLisenabledontheswitch.By
default,SSLisdisabled.
TouseWebView,typetheIPaddressoftheswitchinyourbrowser.TouseWebViewoverSSL,
typeinhttps://thentheIPaddressoftheswitch.
Forexample,https://172.16.2.10.
Commands
show webview
UsethiscommandtodisplayWebViewstatus.
Syntax
show webview
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayWebViewstatus:
C2(rw)->show webview
WebView is Enabled.
set webview
UsethiscommandtoenableordisableWebViewonthesw itch.
Syntax
set webview {enable | disable}
Parameters
For information about... Refer to page...
show webview 3-49
set webview 3-49
show ssl 3-50
set ssl 3-50
enable|disable EnableordisableWebViewontheswitch.