Enterasys SecureStack C2

set dhcp
14-4 DHCP Server Configuration
set dhcp
UsethiscommandtoenableordisabletheDHCPserverfunctionalityontheSecureStackC2.
Syntax
set dhcp {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleenablesDHCPserverfunctionality.
C2(rw)->set dhcp enable
set dhcp bootp
Usethiscommandtoenableordisableautomaticaddressallocationfor BOOTPclients.By
default,addressallocationforBOOTPclientsisdisabled.RefertoRFC1534,“Interoperation
BetweenDHCPandBOOTP,”formoreinformation.
Syntax
set dhcp bootp {enable | disable}
set dhcp exclude 14-7
clear dhcp exclude 14-7
set dhcp ping 14-8
clear dhcp ping 14-8
show dhcp binding 14-9
clear dhcp binding 14-9
show dhcp server statistics 14-10
clear dhcp server statistics 14-10
For information about... Refer to page...
enable|disable EnablesordisablesDHCPserverfunctionality.Bydefault,DHCPserver
isdisabled.