Enterasys SecureStack C2

show snmp user
6-8 SNMP Configuration
Commands
show snmp user
UsethiscommandtodisplayinformationaboutSNMPusers.Thesearepeopleregisteredto
accessSNMPmanagement.
Syntax
show snmp user [list] | [user] | [remote remote] [volatile | nonvolatile | read-
only]
Parameters
Defaults
Iflistisnotspecified,detailedSNMPinforma tionwillbedisplayed.
Ifuserisnotspecified,informationaboutallSNMPuserswillbedisplayed.
Ifremoteisnotspecified,userinformationabouttheloca lSNMPenginewillbedisplayed.
Ifnotspecified,userinformationforallstoragetypeswillbedisplayed.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show snmp user 6-8
set snmp user 6-9
clear snmp user 6-10
show snmp group 6-10
set snmp group 6-12
clear snmp group 6-12
show snmp community 6-13
set snmp community 6-13
clear snmp community 6-14
list (Optional)DisplaysalistofregisteredSNMPusernames.
user (Optional)Displaysinformationaboutaspecificuser.
remoteremote (Optional)DisplaysinformationaboutusersonaspecificremoteSNMP
engine.
volatile|nonvolatile
|read‐only
(Optional)Displaysuserinformationforaspecifiedstoragetype.