Enterasys SecureStack C2

set vlanauthorization
SecureStack C2 Configuration Guide 18-43
Syntax
set policy maptable response {policy | tunnel}
Parameters
Defaults
Settopolicy.
Mode
Switchcommand,read‐write.
Examples
Thisexampleshowshowtosetthepolicymaptableresponsetotunnel:
C2(rw)-> set policy maptable response tunnel
set vlanauthorization
EnableordisabletheuseoftheRADIUSVLANtunnelattributetoputaportintoaparticular
VLANbasedontheresultofauthentication.
Syntax
set vlanauthorization {enable | disable} [port-string]
Parameters
Defaults
VLANauthenticationisdisabledbydefault.
Mode
Switchcommand,read‐write.
Examples
ThisexampleshowshowtoenableVLANauthenticationforallGigabitEthernetports:
C2(rw)-> set vlanauthorization enable ge.*.*
ThisexampleshowshowtodisableVLANauthenticationforallGigabitEthernetportsonswitch
unit/module 3:
policy Setsthemaptableresponsetopolicy.Thisisthedefaultsetting,which
allowsauthenticationofupto2multiauthusersperport.
tunnel Setsthemaptableresponsetotunnel,whichallowsauthenticationofup
to
6multiauthusersperport.ThissettingisrequiredtoconfigureVLAN
authorizationformultipleusersperGigabitport.
enable|disable Enablesordisablesvlanauthorization/tunnelattributes.
port‐string (Optional)SpecifieswhichportstoenableordisabletheuseofVLAN
tunnelattributes/authorization.Foradetaileddescriptionofpossibleport‐
stringvalues,referto“PortStringSyntaxUsedintheCLI”onpage 5‐2.