Enterasys SecureStack C2

show policy maptable response
18-42 Security Configuration
InordertoauthenticatemultipleRFC3580users,policymaptableresponsemustbesettotunnel
asdescribedinthissection.
Commands
show policy maptable response
Displaysthecurrentpolicymaptableresponsesetting.Whenmaptableresponseissettopolicy
(thedefaultsetting)themaximumnumberofmultiauthusersallowedperportis2.Whenthe
maptableresponseissettotunnelthemaximumnumberofmultiauthusersallowedperportis6
.WhenVLANauthorization
isenabled(asde scribedinthissection)andthepolicymaptable
responseistunnel,youcanusethe“setmultiauthport”onpage 18‐35commandtosetthe
numberofRFC3580users(numusers)allowedperGigabitport.Uptosixuserscanbe
configuredperGigabitport
Syntax
show policy maptable response
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythecurrentpolicymaptableresponsesetting:
C2(rw)->show policy maptable response
policy
set policy maptable response
Setsthemaptableresponsefromthedefaultofpolicytotunneltoallowupto6VLANauthorized
userstobeconfiguredperGigabitport.
For information about... Refer to page...
show policy maptable response 18-42
set policy maptable response 18-42
set vlanauthorization 18-43
set vlanauthorization egress 18-44
clear vlanauthorization 18-44
show vlanauthorization 18-45