Enterasys SecureStack C2 User Manual

set ip protocol
SecureStack C2 Configuration Guide 3-11
Example
ThisexampleshowshowtodisplaythemethodusedtoacquireanetworkIPaddress:
C2(su)->show ip protocol
System IP address acquisition method: dhcp
set ip protocol
UsethiscommandtospecifytheprotocolusedtoacquireanetworkIPaddressforswitch
management.
Syntax
set ip protocol {bootp | dhcp | none}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthemethodusedtoacqu ire anetworkIPaddresstoDHCP.
C2(su)->set ip protocol dhcp
show system
Usethiscommandtodisplaysysteminformation,includi ngcontactinformation,powerandfan
traystatusanduptime.
Syntax
show system
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
bootp SelectsBOOTPastheprotocoltousetoacquirethesystemIPaddress.
dhcp SelectsDHCPastheprotocoltousetoacquirethesystemIPaddress.
none NoprotocolwillbeusedtoacquirethesystemIPaddress.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English