Enterasys SecureStack C2 User Manual

SecureStack C2 Configuration Guide 17-1
17
IPv4 Routing Protocol Configuration
ThischapterdescribestheIPv4RoutingProtocolConfigurationsetofcommandsandhowtouse
them.
Activating Advanced Routing Features
Inordertoenableadvancedroutingprotocols,suchasOSPF,DVMRP,VRRP,andPIM‐SM,ona
SecureStackC2device,youmustpurchaseandactivatealicensekey.Ifyouhavepurchasedan
advancedroutinglicense,andhaveenabledroutingonthedeviceasdescribedinprevious
chapters,youcanactivate
yourlicense asdescribedin“ActivatingLicensedFeatures”onpage
15‐3“ActivatingLicensedFeatures”onpage3‐27.Ifyouwishtopurchaseanadvancedrouting
license,contactEnterasysNetworksSales.
Configuring RIP
Purpose
ToenableandconfiguretheRoutingInformationProtocol(RIP).
Router: The commands covered in this chapter can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to “Enabling Router
Configuration Modes” on page 15-2.
For information about... Refer to page...
Activating Advanced Routing Features 17-1
Configuring RIP 17-1
Configuring OSPF 17-10
Configuring DVMRP 17-31
Configuring IRDP 17-34
Configuring VRRP 17-38
Configuring PIM-SM 17-44
Note: The command prompts used in examples throughout this guide show a system where the
VLAN 1 interface has been configured for routing. The prompt changes depending on your current
configuration mode, your specific device, and the interface types and numbers configured for
routing on your system.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English