Enterasys SecureStack C2

clear spantree lp
SecureStack C2 Configuration Guide 7-41
Defaults
Ifnoport‐stringisspecified,statusisdisplayedforallports.
IfnoSIDisspecified, SID0isassumed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayLoopProtectstatusonge.2.3:
C2(su)->show spantree lp port ge.2.3
LoopProtect is disabled on port ge.2.3 , SI
clear spantree lp
UsethiscommandtoreturntheLoopProtectstatusperportandoptionally,perSID,toitsdefault
stateofdisabled.
Syntax
clear spantree lp port-string [sid sid]
Parameters
Defaults
IfnoSIDisspecified, SID0isassumed.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoreturntheLoopProtect stat e onge.2.3todisabled:
C2(rw)->clear spantree lp port ge.2.3
show spantree lplock
UsethiscommandtodisplaytheLoopProtectlockstatusperportand/orperSID.Aportcan
becomelockedifaconfigurednumberofLoopProtectev entsoccurduringtheconfigured
windowoftime.Seethesetspantreelpthresholdandsetspantreelpwindowcommands.Oncea
portisforcedinto
blocking(locked),itremainslockeduntilmanuallyunlockedwiththeclear
spantreelplockcommand.
Syntax
show spantree lplock [port port-string] [sid sid]
port‐string Specif iesport(s)forwhichtocleartheLoopProtectfeaturestatus.
sidsid (Optional)SpecifiesthespecificSpanningTree(s)forwhichtoclearthe
LoopProtectfeaturestatus.Validvaluesare0‐4094.Ifnotspecified,
SID0isassumed.