Enterasys SecureStack C2

Reviewing Port Status
SecureStack C2 Configuration Guide 5-3
Portnumbercanbe:
1–52fortheC2H124‐48,C2H124‐48,C2H124 ‐48P
1–48fortheC2G124‐48andC2G124‐48P
1–24fortheC2G124‐24andC2G124‐24P
1–26fortheC2K122 ‐24
Thehighestvalidportnumberisdependentonthenumberof
portsinthedeviceandtheport
type.
Port Slot/Unit Parameters Used in the CLI
The“unit”parameterisoftenusedinterchangeablywith“module”intheSecureStack CLI to
indicateamoduleslotlocation.
Examples
Thisexampleshowstheport‐stringsyntaxforspecifyingthe1‐GigabitEthernetport14inslotunit
3
.
ge.3.14
Thisexampleshowstheport‐stringsyntaxforspecifyingall1‐GigabitEthernetportsinslotunit3
inthesystem.
ge.3.*
Thisexampleshowstheport‐stringsyntaxforspecifyingallports(ofanyinterfacetype)inthe
system.
*.*.*
Reviewing Port Status
Purpose
Todisplayoperatingstatus,duplexmode,speed,porttype,andstatistical informationabout
trafficreceivedandtransmittedthroughoneorallswitchportsonthedevice.
Commands
Thecommandsusedtoreviewportstatusarelistedbelow.
show port
Usethiscommandtodisplaywhetherornotoneormoreportsareenabledforswitching.
Note: You can use a wildcard (*) to indicate all of an item. For example, ge.3.* would represent all
1-Gigabit Ethernet (ge) ports in slot 3.
For information about... Refer to page...
show port 5-3
show port status 5-4
show port counters 5-5