Enterasys SecureStack C2

set dhcp pool
SecureStack C2 Configuration Guide 14-13
set dhcp pool
UsethiscommandtocreateandassignanametoaDHCPserverpoolofaddresses.Upto16
addresspoolsmaybeconfiguredonaSecureStackC2.Notethatenteringthiscommandisnot
requiredtocreateanaddresspoolbeforeconfiguringotheraddresspoolparameters.
Syntax
set dhcp pool poolname
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplecreatesanaddresspoolnamed“auto1.”
C2(rw)->set dhcp pool auto1
clear dhcp pool
UsethiscommandtodeleteaDHCPserverpoolofaddresses.
Syntax
clear dhcp pool poolname
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampledeletestheaddresspoolnamed“auto1.”
C2(rw)->clear dhcp pool auto1
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
poolname Specif iesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.