Enterasys SecureStack C2

set dhcp ping
14-8 DHCP Server Configuration
Example
ThisexampleclearsthepreviouslyexcludedrangeofIPaddressesbetween192.168.1.88through
192.168.1.100.
C2(rw)->clear dhcp exclude 192.168.1.88 192.168.1.100
set dhcp ping
UsethiscommandtoconfigurethenumberofpingpacketstheDHCPserversendstoanIP
addressbeforeassigningtheaddresstoarequestingclient.
Syntax
set dhcp ping packets number
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsthenumberofpingpacketssentto3.
C2(rw)->set dhcp ping packets 3
clear dhcp ping
UsethiscommandtoresetthenumberofpingpacketssentbytheDHCPserverbacktothe
defaultvalueof2.
Syntax
clear dhcp ping packets
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
packetsnumber Specifiesthenumberofpingpacketstobesent.Thevalueofnumbercan
be0,orrangefrom2to10.Entering0disablesthisfunction.Thedefault
valueis2packets.