Enterasys SecureStack C2

SecureStack C2 Configuration Guide 1-1
1
Introduction
ThischapterprovidesanoverviewoftheSecureStackC2’suniquefeaturesandfunctionality,an
overviewofthetasksthatmaybeaccomplishedusingtheCLIinterface,anoverviewofwaysto
managetheswitch,factorydefaultsettings,andinformationabouthowtousetheCommandLine
Interfacetoconfiguretheswitch.
SecureStack C2 CLI Overview
EnterasysNetworks’SecureStackC2CLIinterfaceallowsyoutoperformavarietyofnetwork
managementtasks,includingthefollowing:
•UseCLIcommandstoperformnetworkmanagementandswitchconfigurationoperations.
• Downloadanewfirmwareimage.
• AssignIPaddressandsubnetmask.
•Selectadefaultgateway.
•EstablishandmanageVirtualLocalAreaNetworks(VLANs).
•Establish
andmanagepolicyprofilesandclassifications.
•Establishandmanagepriorityclassification.
• ConfigureIPv4routingandroutingprotocols,includingRIPversions1and2,OSPF,DVMRP,
IRDPandVRRP.
• ConfigureIPv6routingandroutingprotocols,includingOSPFv3.
• Configuresecurityprotocols,including802.1XandRADIUS,SSHv2,PWA,MAClocking,and
MACauthentication.
• Configureaccesscontrol
lists(ACLs).
Switch Management Methods
TheSecureStackC2switchcanbemanagedusingthefollowingmethods:
•LocallyusingaVTtypeterminalconnectedtotheconsoleport.
For information about... Refer to page...
SecureStack C2 CLI Overview 1-1
Switch Management Methods 1-1
Factory Default Settings 1-2
Using the Command Line Interface 1-6