Enterasys SecureStack C2 User Manual

show boot system
SecureStack C2 Configuration Guide 3-33
Commands
Thecommandsusedtoreviewandselecttheswitch’sbootimagefilearelistedbelow.
show boot system
Usethiscommandtodisplaythefirmwareimagetheswitchloadsatstartup.
Syntax
show boot system
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaytheswitch’sbootfirmwareimage:
C2(su)->show boot system
Current system image to boot: bootfile
set boot system
Usethiscommandtosetthefirmwareimagetheswitchloadsatstartup.
Syntax
set boot system filename
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
For information about... Refer to page...
show boot system 3-33
set boot system 3-33
filename Specifiesthenameofthefirmwareimagefile.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English