Enterasys SecureStack C2

clear tftp timeout
3-44 Basic Configuration
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsthetimeoutperiodto4seconds.
C2(rw)->set tftp timeout 4
clear tftp timeout
UsethiscommandtoresettheTFTPti meoutvaluetothedefaultvalueof2seconds.
Syntax
clear tftp timeout
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearthetimeoutvaluetothedefaultof2seconds.
C2(rw)-> clear tftp timeout
set tftp retry
UsethiscommandtoconfigurehowmanytimesTFTPwillresendapacket,eitheran
acknowledgementpacketoradatapacket.
Syntax
set tftp retry retry
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
retry Specifiesthenumberoftimesapacketwillberesent.Thevalidrangeis
from1to1000.Defaultvalueis5retries.