To Next Page

To Previous Page

show pwa

18-58 Security Configuration

show pwa

Usethiscommandtodisplayportwebauthenticationinformationforoneormoreports.

Syntax

show pwa [port-string]

Parameters

Defaults

Ifport‐stringisnotspecified,PWAinformationwillbedisplayedforallports.

Mode

Switchcommand,read‐only.

Example

ThisexampleshowshowtodisplayPWAinformationforge.2.1:

C2(su)->show pwa ge.2.1

PWA Status - enabled

PWA IP Address - 192.168.62.99

PWA Protocol - PAP

PWA Enhanced Mode - N/A

PWA Logo - enabled

PWA Guest Networking Status - disabled

PWA Guest Name - guest

PWA Redirect Time - N/A

Port Mode AuthStatus QuietPeriod MaxReq

-------- ---------------- -------------- ----------- ---------

ge.2.1 disabled disconnected 60 16

Table 18‐8providesanexplanationofthecommandoutput.

set pwa quietperiod 18-65

set pwa maxrequest 18-66

set pwa portcontrol 18-66

show pwa session 18-67

set pwa enhancedmode 18-68

For information about... Refer to page...

port‐string (Optional)DisplaysPWAinformationforspecificport(s).

Table 18-8 show pwa Output Details

Output What It Displays...

PWA Status Whether or not port web authentication is enabled or disabled. Default state of

disabled can be changed using the set pwa command as described in “set pwa” on

page 18-59.

Enterasys SecureStack C2 User Manual

Questions and Answers: