Enterasys SecureStack C2

set multiauth port
SecureStack C2 Configuration Guide 18-35
set multiauth port
Usethiscommandtosetmultipleauthentication propertiesforoneormoreports.
Syntax
set multiauth port mode {auth-opt | auth-reqd | force-auth | force-unauth} |
numusers numusers port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosettheportmultipleauthenticationmodetorequiredonge.3.14:
C2(rw)->set multiauth port mode auth-reqd ge.3.14
clear multiauth port
Usethiscommandtoclearmultipleauthenticati onpropertiesforoneormoreports.
Syntax
clear multiauth port {mode | numusers} port-string
Parameters
mode
auth‐opt|
auth‐reqd|
force‐auth|
force‐unauth
Specifiestheport(s)’multipleauthenticationmodeas:
• auth‐opt—Authenticationoptional(“non‐strict”behavior).Ifauser
doesnotattempttoauthenticateusing802.1x,orif802.1x
authenticationfails,theportwillallowtraffictobeforwarded
according
tothedefined defaultVLAN.
• auth‐reqd—Authentication isrequired.
• force‐auth—Authenticationconsidered.
• force‐unauth—Authenticationdisabled.
numusers
numusers
Specifiesthenumberofusersallowedauthenticationonport(s).Valid
valuesare0to8.
port‐string Specifiestheport(s)onwhichtosetmultipleau thenticationproperties.
mode Clearsthespecifiedport’smultipleauthenticationmode.
numusers Clearsthevaluesetforthenumberofusersallowedauthenticationonthe
specifiedport.
port‐string Specifiestheportorportsonwhichtoclearmultipleauthentication
properties.