Enterasys SecureStack C2

Managing Switch Network Addresses and Routes
SecureStack C2 Configuration Guide 12-15
Managing Switch Network Addresses and Routes
Purpose
TodisplayordeleteswitchARPtableentries,andtodisplayMACaddressinformation.
Commands
show arp
Usethiscommandtodisplaytheswitch’sARPtable.
Syntax
show arp
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show arp 12-15
set arp 12-16
clear arp 12-17
traceroute 12-17
show mac 12-18
show mac agetime 12-19
set mac agetime 12-20
clear mac agetime 12-20
set mac algorithm 12-21
show mac algorithm 12-21
clear mac algorithm 12-22
set mac multicast 12-22
clear mac address 12-23
show mac unreserved-flood 12-24
set mac unreserved-flood 12-24